Attaching XBox controller to Craft Tools

Got questions, comments and/or feedback regarding Craft Director Studio? Post them here.
Forum rules
We only allow posts that
  • Is in English
  • Is related to our tools and the programs they support.

If these rules are not met you are most likely going to be banned.

Please Note:
  • New users will have their posts reviewed before being publicly available for other to see.
Post Reply
chprcash28
Posts: 1
Joined: Tue Nov 25, 2008 4:09 am

Attaching XBox controller to Craft Tools

Post by chprcash28 » Tue Nov 25, 2008 4:13 am

Is it possible to use the Xbox controller in Craft Tools. If so, how do you get Craft to recognize it?
thanks!
Top
Carl Buhre
Quality Assurance Consultant
Posts: 438
Joined: Mon Feb 25, 2008 12:59 pm
Location: Gothenburg, Sweden
Contact:
Contact Carl Buhre

Re: Attaching XBox controller to Craft Tools

Post by Carl Buhre » Tue Nov 25, 2008 9:17 am

chprcash28 wrote:Is it possible to use the Xbox controller in Craft Tools. If so, how do you get Craft to recognize it?
thanks!
Are you having problems auto detecting the xbox controller? We've tried Craft Director Tools with a wired xbox 360 controller so I know it should work.

Are you sure you checked "Joystick device" during the installation process? Please download the latest version of Craft Director Tools and run the installation again (no need to uninstall anything, just remember that 3ds MAX/Maya can't be running during the installation) and make sure you check "Joystick device". Then start 3ds MAX/Maya and try auto detecting again.
Image
Top
cdunwald
Posts: 2
Joined: Wed Nov 26, 2008 8:54 pm

Re: Attaching XBox controller to Craft Tools

Post by cdunwald » Wed Nov 26, 2008 9:20 pm

I was wondering what drivers you have for the XBOX controller. I can't get it to work in windows XP. (Not a 360 controller) Windows recognizes the controller and I can configure the buttons etc in the control panel, however I cannot get Max (9) to recognize it when i go to control a vehicle.

Any suggestions would be greatly appreciated.

thx!
Top
Carl Buhre
Quality Assurance Consultant
Posts: 438
Joined: Mon Feb 25, 2008 12:59 pm
Location: Gothenburg, Sweden
Contact:
Contact Carl Buhre

Re: Attaching XBox controller to Craft Tools

Post by Carl Buhre » Fri Nov 28, 2008 3:43 pm

cdunwald wrote:I was wondering what drivers you have for the XBOX controller. I can't get it to work in windows XP. (Not a 360 controller) Windows recognizes the controller and I can configure the buttons etc in the control panel, however I cannot get Max (9) to recognize it when i go to control a vehicle.

Any suggestions would be greatly appreciated.

thx!
Cdunwald, are you sure you checked "Joystick device", as mentioned above, during the installation process? We did not use any special drivers when we tried the xbox360-controller, just plugged it in and started 3ds MAX/Maya.
Top
Post Reply

Return to “Craft Director Studio - Help, Feedback and more”

Who is online

Users browsing this forum: No registered users and 41 guests