1- Is it possible to change the time when a simulation happens? (without unpluggin)
May be deleting all the keyframes and starting over in another frame.
thanks
move simulation (frames)?
Forum rules
We only allow posts that
If these rules are not met you are most likely going to be banned.
Please Note:
We only allow posts that
- Is in English
- Is related to our tools and the programs they support.
If these rules are not met you are most likely going to be banned.
Please Note:
- New users will have their posts reviewed before being publicly available for other to see.
-
Micael Belin
- CTO
- Posts: 168
- Joined: Thu Apr 03, 2008 9:39 am
- Location: Gothenburg, Sweden
- Contact:
Re: move simulation (frames)?
Hi,
Unfortunately, you cannot move the simulation time. Either finish the recording, unplug and then move the keys. Otherwise i would simply recommend you to make the recording again, this time on the correct timeframe. Unless you have a very complicated recording, it usually doesn't take too much time to re-record the event.
Unfortunately, you cannot move the simulation time. Either finish the recording, unplug and then move the keys. Otherwise i would simply recommend you to make the recording again, this time on the correct timeframe. Unless you have a very complicated recording, it usually doesn't take too much time to re-record the event.
[email protected]
http://www.craftanimations.com
http://www.craftanimations.com
Who is online
Users browsing this forum: No registered users and 81 guests