Speed Spline Controller

Got questions, comments and/or feedback regarding Craft Director Studio? Post them here.
Forum rules
We only allow posts that
  • Is in English
  • Is related to our tools and the programs they support.

If these rules are not met you are most likely going to be banned.

Please Note:
  • New users will have their posts reviewed before being publicly available for other to see.
Post Reply
jigi525
Posts: 6
Joined: Thu Dec 16, 2010 1:57 pm

Speed Spline Controller

Post by jigi525 » Tue Jan 18, 2011 2:39 pm

hi,

I'm using craft director 10.1.2. Currently I'm working on Speed Spline controller. I activate the Autonomus - tight mode in it.....At low speeds the 4-wheeler extended is following the carriage tightly....but on increasing the speed of the waypoints, the carriage increases its speed but the 4 wheeler extended gets left behind and follows slowly......tried other profiles too but no luck...Can anyone help me achieve a tightly following 4 wheeler extended configuration.?? What values need to be manipulated for it?? The Autonomous Mode Follow Strength and the Follow Strength Response Factor don't seem to help... :( :(
Need to work on the project ASAP !!!

Thanxx :)
Top
Patrik Martin
Partner
Posts: 416
Joined: Mon Feb 25, 2008 1:07 pm
Location: Gothenburg, Sweden
Contact:
Contact Patrik Martin

Re: Speed Spline Controller

Post by Patrik Martin » Tue Jan 18, 2011 2:42 pm

For the 4-Wheeler Extended increase the Gas Pedal (Forw/Backw) value in the configuration. That should make it catch up.
Partner
http://www.craftanimations.com
patrik.martin-at-craftanimations.com
Top
Post Reply

Return to “Craft Director Studio - Help, Feedback and more”

Who is online

Users browsing this forum: No registered users and 92 guests